Thermal radiation melting drop tester experimental parameters

 The hot irradiation melting drop tester is a test for the NFP92-505 and EU95/28/EC standards specified in Appendix 7 of ECE R118 to determine the melting characteristics of the material. The equipment is integrated with electromechanical control, and the outer box cold plate is treated with orange paint. The box has strong acid resistance inside and outside and a long service life.

As a modern technology enterprise integrating R&D, manufacturing, sales, training, and service, Shanghai Qianshi Precision Electromechanical Technology Co., Ltd. is committed to delivering more testing instruments to the market, providing testing instruments for textiles, leather, combustion, automotive interior, and exterior trims, material environmental climate aging, etc., and non-standard customization is also acceptable. Targeted tests can be carried out according to customer requirements before purchase to ensure that the purchased instruments are suitable.

☞If you want to consult more information about test equipment, you can browse our website, find us, and get more test solutions:

https://www.qinsun-lab.com/index.html

Test principle:

Place the sample on the support, the distance between the sample and the radiation surface is 30mm; the container including cotton wool is placed 300mm below the support pot grid. Move the electric heater to the side where the radiation does not reach the sample crystal, turn on the switch, wait for it to run, and then put it back above the sample and start timing. If the material melts and deforms, keep the electric heater at a height of 30mm2; in the first 5 minutes of the test, if the material starts to burn, push the electric heater to the side for three seconds, wait for the flame to go out, and then move it back to the original position. Repeat the same operation, and finally see if the droplets fall to burn or ignite the cotton.

Experimental parameters:

1. Sample holder: stainless steel ring with an inner diameter of 118mm, stainless steel mesh with an inner diameter of 0.70mm, and mesh size of 2.10mm

2. Sample size: 70x70 (mm), thickness not exceeding 13mm

3. Residue container: inner diameter 118mm, depth 12mm

4. Radiant heat source power: 500W (optional)

5. Radiant heat source radiation surface: transparent glass plate with a diameter of 100mm±5mm

6. Distance between residue container and sample holder: 300mm

7. Distance between sample upper surface and radiation source surface: 30mm

8. Heat flux meter range: 10W/cm (optional)

Main features:

1. Stainless steel heat radiator holder, which can be rotated 90 degrees for quick testing

2. Equipped with a height gauge for sample distance from heat radiation device to facilitate adjustment of test height

3. Epiradiator heat radiation device, can provide 30KW/m2 heat radiation flux

4. The panel displays the operating power value of the heat radiation device, eliminating the need for frequent calibration procedures

5. The power controller controls the radiation output and can adjust the radiation amount of the heat radiation device

6. Equipped with a sample and cotton tray, the height is adjustable and can be easily evacuated from the radiation source